Pull back the wired multi-plug unit and remove from bulb terminals. We stock headlight parts for most Land Rover models including , , and. You will need a new bulb or bulbs - make sure that you get the right ones for your car, Phillips screwdriver and alcohol wipes and tissues. You will see the slot that the fitment is intended to slide through. Step 4: Clean and install the new headlight bulb - You do not want the oils from your skin getting on the new bulb, so handle it with gloves on or tissues. When in place the nubs sit into mounting holes.
I ve got it, I have to search it. This makes them a highly important part of your vehicle. Raise the headlamp retainers by pushing rearward and pulling up. Using latex gloves or another barrier is recommeded. Attach the bulb electrical connector. Make note how thermostat is installed.
In some cases, it might be necessary to rotate the bulb to get it out of the holder. The job is relatively easy, so you can do it yourself. I just got a 2000 Disco and have been looking into this as well. I am determined to do it anyway. Open the plastic plate no tool required located on the grill side of headlight unit and unscrew the Phillips head bolt that holds the bottom of the unit in place.
When in place the nubs sit into mounting holes. Take care not to get any contaminants on the bulb or finger prints. Remove large rubber gasket to expose back of bulb. The spring is held in place by two screws on one side which act as the hinge for the spring to swing open like a gate. This does, indeed, seem doable, and my stock headlights need to be changed one way or another - I figured, might as well do it as an improvement rather than plain repair. Pull each nub towards the car and when free of the little hole move the short distance 10 degrees towards the left.
Re-fill coolant slowly to … prevent an airlock. The tough engineering of Land Rover cars and trucks includes tough off road performance and high end interior features. This must be a beat up topic, but I couldn't find any step-by-step info on that topic. You just need a few inches of wiggle room. Before installing it, clean it well with an alcohol wipe. This itself might be the problem due to there being a little corrosion build up and not an actual bulb burnout.
If you do then the bulb must be cleaned thoroughly. Start engine and look for leaks. You will find it in a bulb holder, with three wires, known as a power connector, leading to the bulb. Open the hood and then: 1. We stock these Headlight brands for the Land Rover Discovery: Genuine.
If it is a metal clip, pull the clip up and then away, ensuring that you hold on to it as it is pulled. When you picked your Land Rover, you chose a car or truck with great performance and notable style; you should backstop that investment by using only the most top-notch parts. Land Rover vehicles are carefully designed to offer high end interior elegance and rugged rough road drivability. This itself might be the problem due to there being a little corrosion build up and not an actual bulb burnout. Remove the grill by removing 3 plastic screws holding top of grill and pull the grill up and out. Ã¨ The headlamp bulb should not be removed from the headlamp until just before a replacement bulb is installed.
Raise and support the hood. A Land Rover Discovery Headlight is among the most important element installed on the vehicle regarding hazard-free travel on dark roads or in heavy conditions. Step 2: Remove the power wires-You will find the power wires attached to a plug at the headlight base, held by, a metal clip, a screw cap or a plastic catch, depending on your vehicle. You will see the slot that the fitment is intended to slide th … rough. Open the hood and find the headlight that is near your vehicle's front. There are three plastic nubs attached to the headlamp mounting fixture.